Page 1 of 1
Two Sat Ops question
Posted: 08 Sep 2022, 03:15
by KA7KDX
I have an IC-9700 and an Az/El rotator.
Are there any options to get BOTH the uplink and downlink frequencies?
Is it possible to just GET Az/El rotator angles?
very general questions, so I'm looking for experiences and options.
thanks in advance.
b
Re: Two Sat Ops question
Posted: 08 Sep 2022, 07:04
by G4POP
First update to version 2
Re: Two Sat Ops question
Posted: 09 Sep 2022, 01:30
by KA7KDX
Version 2.23.0.0
Re: Two Sat Ops question
Posted: 09 Sep 2022, 07:35
by G4POP
Moved this thread to version 2 forums where you will get more response, no one looks at v1 forum because V1 has been obsolete for a couple of years
Re: Two Sat Ops question
Posted: 09 Sep 2022, 14:39
by KA7KDX
ahh, yah, I see where I made the mistake. Thanks for taking care of it.
Re: Two Sat Ops question
Posted: 19 Nov 2022, 19:39
by DL6JZ
Hi KA7KDX,
I am using the IC-9700 in SAT mode. And I couldn't find the correct settings for the CAT Interface. I didn't see any frequency but the mode only.
Then I modified the OmniRig ini file so that I get the frequency of the main band now.
Can you tell me your settings for the IC-9700 in SAT mode?