Page 1 of 1
Alert problem
Posted: 06 May 2023, 06:54
by F6FLU
Good morning
my alert for DX0NE is not working but I don't know why, other alerts are working fine
If you had some good ideas
THANKS
- 2023-05-06 08_52_37.jpg (51.23 KiB) Viewed 836 times
- 2023-05-06 08_52_31.jpg (53.77 KiB) Viewed 836 times
- 2023-05-06 08_52_25.jpg (38.96 KiB) Viewed 836 times
Re: Alert problem
Posted: 08 May 2023, 16:29
by F6FLU
No response, it's amazing
Nobody has a problem with the alarms?
Re: Alert problem
Posted: 08 May 2023, 19:14
by KI5IO
Dan,
I created an alert for dx0ne and did a simulation test and it worked FB for me.
For Sources I chose: "Cluster" I did not utilize or even test "Any"
For Band/Mode I did not make any selections as if you leave as: "no selection" Log4OM assumes ALL.
I'll give another test with "Any" and see if that causes me what you are experiencing.
.
Re: Alert problem
Posted: 08 May 2023, 19:24
by KI5IO
Dan,
I just did 3 tests (Spot Simulation) with the "Any" Source chosen and did NOT get an alert on any of the tests.
Looks like you might have come across a bug where the "Any" Source is not functioning as intended and/or broke.
I'll advise Lele and Terry.
Re: Alert problem
Posted: 08 May 2023, 20:38
by F6FLU
Hello
Thank you very much Nolan for doing all these tests
This reassures me, I'm not just talking nonsense
73
Re: Alert problem
Posted: 09 May 2023, 10:03
by KI5IO
F6FLU wrote: ↑08 May 2023, 20:38
Hello
Thank you very much Nolan for doing all these tests
This reassures me, I'm not just talking nonsense
73
Dan,
Lele corrected and it now tests FB on an Alpha release we're working on.
Re: Alert problem
Posted: 09 May 2023, 11:38
by F6FLU
OK Nolan,
Thanks
Re: Alert problem
Posted: 25 May 2023, 12:43
by KI5IO
Dan,
Check out V 2.27.1.10 that Lele has posted to the website:
https://www.log4om.com/download/
Re: Alert problem
Posted: 25 May 2023, 18:17
by F6FLU
OK Nolan thank you not tested here yet...
Thanks