Log4OM

ciao Howard ,

I did a check and based on the information provided all seems to be fine.

I have only 2 questions:

1) why do you use RIG2 instead of RIG1 ?

2) do you have other vitual port emulator working in the same time with smartcat ? (you can also check in system resource if there are other com port available not defined by the smartcat ).

try also to create a new "dedicated" port in smartcat (com5) and try to use COM5 instead of com4

keep us informed !

Not sure how you would create a new port. I used rig2 until I am sure I am going to keep the 6300.
I don't have anything else running. Smartsdr cat say to use port 4.
Which interface should i use TS-2000 or what?

Your help is appreciated.
Thanks

Howard
AH6TX

the ts2000 is the right one.
check also the manual of log4om where you can find
a specific paraghaph I wrote on flex signature integration
let me know

Thanks for your info. I found the info in the manual, however the SMART CAT indicates to go to COM4. How can I change that for 5 as it indicates in the manual? Smart Cat has some options but I don't know how to use them. Please advise.

Thanks

Howard
AH6TX

enter in the smartcat menu and create a new port as dedicated (not shared, not ptt).
have a look at smartcat manual as it is fully explained

have looked for the manual and can't find it. I have smartsdr cat ver 1.2.8.0. If you have a copy can you send it to me. [email protected]

Thanks

Howard

manual sent !

AH6TX wrote:have looked for the manual and can't find it. I have smartsdr cat ver 1.2.8.0. If you have a copy can you send it to me. [email protected]

Thanks

Howard

In Log4om go to help/help/English - Force update then view the downloaded help file

Alternatively the manual download link is just below the link you used to download the program

Page 201 refers

hi Howard
was you able to do make 6300 integrating with log4om ?

if you need support I am available in the weekend also on skype

let me know