Log4OM

Weird thing going on here ...
I got my N1MM loging program finally up and running to use in CW contestmode in combination with my IC7300.
Sidething to that is when I start my Log4om program ... which I use the most for all other qso's ... and the moment I put my rig into CW mode ... or when I click a CW station in the bandmap of Log4om ... my 7300 is going into TX and starts to send a sidetone in the air.
When I switch my rig back in SSB ... or I click a SSB station in the bandmap ... it goes back in RX.

With Log4om opened and a CW station clicked in the bandmap ... as soon I set my IC7300 in .... Menu/Set/Connectors/USB SEND Keying / USB Keying (CW) ... in DTR or RTS ... my IC7300 goes in CW transmit. I swotch it back to OFF and it goes back in RX.
Why ... I have no clue for the moment ...
Can someone help me here ?

Are N1MM and Log4OM both running at the same time?

If so close N1MM or read our user guide regarding N1MM integration set up

No they aren't
It's only Log4om which makes this happen even with N1MM closed.

Are you using Hamlib or Omnirig?

I'm using Omnirig and it was there where the issue was.
A post on the forum over here set me in the right direction.
In my case in the Omnirig settings had to be put ;
RTS to High
and
DTR to low
Toggling DTR High/Low switched my IC7300 in TX/RX ... so it has to be set on Low in my case.
All problems solved.
Both logging programs work like they should now :p

The link to the post:
https://forum.log4om.com/viewtopic.php?t=3107