Log4OM

When I try to edit QSOs (i.e. right click on QSO in Recent QSO's), I get the page EDIT QSO, but it is blank (in the tool bar only) and not executable. Same for trying to update my Incoming UDP paths. I changed to run as administrator and still nothing.

Bob N4RF

Try a clean install of the latest Beta version please

I am on version 2.32.1.0
I couldn't find any other beta version to upload.
Bob

So a fresh download of that version and then a clean install

I did install the latest version of Log4OM two times with no results.
I may have a problem with my computer.
73,
Bob N4RF

N4RF wrote: 24 May 2024, 17:48 I did install the latest version of Log4OM two times with no results.
I may have a problem with my computer.
73,
Bob N4RF

But did you do a clean install by removing all user files in addition to uninstallig the software?

Obviously after making backups for security

For backing up, do I just do that under the file menu and then uninstall from the program file section.

I am nervous, hi. I need Doug NN7Dd, hi. I am so unskilled with computers. Just a simple minded CW guy.

Bob N4RF

N4RF wrote: 25 May 2024, 11:07 For backing up, do I just do that under the file menu and then uninstall from the program file section.

I am nervous, hi. I need Doug NN7Dd, hi. I am so unskilled with computers. Just a simple minded CW guy.

Bob N4RF

Hi Bob,

Then best to not try this but rather find someone locally who could fix it via teamviewer or similar

I uninstalled Log4OM and reinstalled it. I still can not edit a QSO or UDP.

For some strange reason every QSO is being logged twice. I thought my incoming UDP needed to be changed.

I have ADIF Message JTAlert Logging 2235, JTAlert Rebrodcast 12040 and N1MM Message/Logging 12060. The manual has different numbers (addresses?), but Log4OM won't allow me to edit the UDP Inbound Connections. They are a blank page in the tool bar. Clicking on them does nothing.

You edit them in settings/program config/connections