Page 1 of 1
PST ROTATOR AND LOG4OM2 ERROR IN TRACKING MODE
Posted: 12 Mar 2025, 18:06
by I2OLV
Hi, I'm using LOG4OM2 and PST Rotator to control a Yaesu G-2800DXC via a JZG RS232/USB interface and it works ok but only in Manual mode. All the softwares setup have been done properly using UDP control. But when I try to set Tracking Mode on PSTR it gives me the following error: "LOG4OM Tracking Error" (see attachment). Is there a way to solve this? Thanks. I2OLV
Re: PST ROTATOR AND LOG4OM2 ERROR IN TRACKING MODE
Posted: 05 Apr 2025, 13:45
by I2OLV
Does anyone have a feedback on this?
Thanks
Re: PST ROTATOR AND LOG4OM2 ERROR IN TRACKING MODE
Posted: 05 Apr 2025, 18:08
by CT1BXX
I2OLV wrote: 05 Apr 2025, 13:45
Does anyone have a feedback on this?
Thanks
Hi,
I used PSTRotator without any issue.
I also have it to command my remote antena switch.
For long time I do not use anymore because problems with antennas.
As far I remember it is necessary in PSTRotator/Tracker choose Log4OM.
Have you tested only PST Rotator without Log4OM?
If it works manualy only PSTRotator, please check UDP configuration in Log4OM.
I am sorry not giving a big help, but it is waht I can remember, and again, in my case it worked really very well.
Have a nice day, and good work.
- rotor2.jpg (114.07 KiB) Viewed 3964 times
- Rotor.jpg (102.49 KiB) Viewed 3964 times