Log4OM

Hello!
I use a remote station where, of course, I have a PC connected to the radio (Elecraft K3).
I wish to CAT that radio with BOTH (1) the PC at the remote site and (2) the PC at my desk, here, downtown.

I already have Log4OM installed on both computers but actually I have configured the CAT succesfully at the remote site only.

I have SDC, Omnirig and the IK0VVE or2or.exe software but I don't know haw/where to start.

I am a newcomer with Log4OM and it will be very hard for me, due to lack of time, to leave my MacLoggerDX software with over 85K QSO logged, but I will try!

I look forward for help from this community and wish all of you good DX and luck.

73 de Fabio, IT9GSF - One of the II9P/IG9A team.

Best use Teamviewer or Anydesk to remotely control the software at the remote site

I have one monitor only at the remote site and three here at home. I need not a so easy solution. Regards, Fabio.

Also, please, consider I have a local station at my home and I would like to connect (cat) a second and third radio here.
CUL,
Fabio.

So use one local screen for Anydesk to remote PC

And using your local install of Log4OM control the other two rigs via Omnirig locally on the other two screens

THANK YOU!