My problem:
Configuration: LOG4OM, WIN4Icom,WSJT-X, activated in setup but not started: FLdigi
After program start the CALLSIGN field is automatic filled with an old call sign.
After deleting the entry in main window- it comes back as active if adjusting anything on the radio (udp).
Load new entry from cluster- radio gets correct CI-V commands, then reloads the old call sign.
Stop WSJT-X application- all works fine...
73!
Wolfgang
overloading CALLSIGN field with old entry
Re: overloading CALLSIGN field with old entry
Wolfgang,
That is picking up the ADIF feed from WSJT-x and filling in the last QSO you had via that APP.
That is picking up the ADIF feed from WSJT-x and filling in the last QSO you had via that APP.
73 - Nolan Kienitz - KI5IO
Plano, TX
Plano, TX
Re: overloading CALLSIGN field with old entry
Hi, Nolan,
thank you for the input, I think, I found now a workaround.
All works correct if the last FT*-qso was successful finished in WSJT-X with a log entry.
In other case active call sign will been stored in the WSJT-X.ini file and then it is the default value until manual deleting the entry or run a qso with a log entry...
73!
Wolfgang
thank you for the input, I think, I found now a workaround.
All works correct if the last FT*-qso was successful finished in WSJT-X with a log entry.
In other case active call sign will been stored in the WSJT-X.ini file and then it is the default value until manual deleting the entry or run a qso with a log entry...
73!
Wolfgang
