Omni-Rig & Two Transceivers Display in Log4OM Query

[G7RVH]

I have two transceivers connected to Log4OM V2.3.0.0 using Omni-Rig V1.19. Both are working with the ability to change mode and frequency etc.

My question is that I am only seeing one rig displayed rather that two. I can switch between them fine but can only see one at a time in the left hand CAT display. The right hand side remains blank. Same behaviour if I open the CAT screen.

Read the manual etc. and concluded that I'm in need of some help! What should I be expecting in terms of dual rig and display within Log4OM V2?

Many thanks,

Richard
G7RVH
Norfolk, UK

[KI5IO]

I have two transceivers connected to Log4OM V2.3.0.0 using Omni-Rig V1.19. Both are working with the ability to change mode and frequency etc.

My question is that I am only seeing one rig displayed rather that two. I can switch between them fine but can only see one at a time in the left hand CAT display. The right hand side remains blank. Same behaviour if I open the CAT screen.

Read the manual etc. and concluded that I'm in need of some help! What should I be expecting in terms of dual rig and display within Log4OM V2?

Many thanks,

Richard
G7RVH
Norfolk, UK

Richard,

The dual-display is for VFO A & VFO B of a single-rig.

[G7RVH]

Many thanks for the prompt response and clarifying the behaviour of Log4OM. I'll investigate that option further.

[G4POP]

Richard
Not all radios have the capability of sending vfo b information via CAT

This is why we prefer you provide full information when posting on the forum like rig, OS, Interface, Log4om version number

Let us know what radio your using and we can probably save you some head scratching