CW port is not saved

[F6FLU]

Hello
for the first time I test the CW function and it works well except that when I leave this CW part the port selected for this CW is not saved, a particular manipulation to do or this problem is already known?
thank you for your comments
73

[F6FLU]

I think the answer is :
After use the Winkeyer must be disconnected by clicking the connect icon again before the Winkeyer window is closed

[G4POP]

I think the answer is :
After use the Winkeyer must be disconnected by clicking the connect icon again before the Winkeyer window is closed

Of course otherwise the port is not closed properly

[F6FLU]

OK Terry

Thanks for this confirmation
73

[KI5IO]

Dan,

I experience the same process when I use the Elecraft K3 & P3 Utilities. If I forget to close the port and just shut down those Utility APPs the port remains open. Same for when I use the WK3Tools and WK3Demo APPs from the Winkeyer folks.

The process utilized/expected is not unique to L4OM V2.