IC7300 going in sidetone TX when Log4om in CW mode

[ON1JV]

Weird thing going on here ...
I got my N1MM loging program finally up and running to use in CW contestmode in combination with my IC7300.
Sidething to that is when I start my Log4om program ... which I use the most for all other qso's ... and the moment I put my rig into CW mode ... or when I click a CW station in the bandmap of Log4om ... my 7300 is going into TX and starts to send a sidetone in the air.
When I switch my rig back in SSB ... or I click a SSB station in the bandmap ... it goes back in RX.

With Log4om opened and a CW station clicked in the bandmap ... as soon I set my IC7300 in .... Menu/Set/Connectors/USB SEND Keying / USB Keying (CW) ... in DTR or RTS ... my IC7300 goes in CW transmit. I swotch it back to OFF and it goes back in RX.
Why ... I have no clue for the moment ...
Can someone help me here ?

[G4POP]

Are N1MM and Log4OM both running at the same time?

If so close N1MM or read our user guide regarding N1MM integration set up

[ON1JV]

No they aren't
It's only Log4om which makes this happen even with N1MM closed.

[G4POP]

Are you using Hamlib or Omnirig?

[ON1JV]

I'm using Omnirig and it was there where the issue was.
A post on the forum over here set me in the right direction.
In my case in the Omnirig settings had to be put ;
RTS to High
and
DTR to low
Toggling DTR High/Low switched my IC7300 in TX/RX ... so it has to be set on Low in my case.
All problems solved.
Both logging programs work like they should now :p

The link to the post:
https://forum.log4om.com/viewtopic.php?t=3107