No Omnirig and no Log4OM

[PD4P]

I have been working with Omnirig and Log4OM recently. After an update of Windows (24h2) both programs stopped. I have reinstalled Windows and forbid Windows to update any further so that I know for sure that 24H2 will not come to me. However, the problems with Omnirig and Log4OM did not disappear. When I start Omnirig and Log4OM (both as Administrator) they appear together on my screen. I have set everything correctly in Omnirig and I see it in the device manager under "Apps". When I press OK on Omnirig it disappears and I do not see it in the device manager under "Background Processes". So I start it again but now i leave Omnirig on my screen without pressing OK. Then I spend my time on LOG4OM. In the Cat Management Omnirig is listed as Cat Engine and a check mark at CAT auto-start. I can now stop and start the CAT in Log4OM but the frequency reading remains on "Offline". Is there something wrong with omnirig because after pressing OK it is no longer under processes and I think it does not do its job? Omnirig is V1.20, Log4OM v2.35.1.0. Who has the solution?
Regards, Pieter de PD4P

[PD4P]

Extra Info: I went back from version 2.35 to 2.34 and everything is working fine!!!

[KI5IO]

Dunno what your hiccup is.

I updated my W-11 O/S to Version 24H2 on December 7, 2024 and have not had any issues whatsoever.

I also use OmniRig and the most current release of Log4OM V2.