Connecting remote site

[it9gsf]

Hello!
I use a remote station where, of course, I have a PC connected to the radio (Elecraft K3).
I wish to CAT that radio with BOTH (1) the PC at the remote site and (2) the PC at my desk, here, downtown.

I already have Log4OM installed on both computers but actually I have configured the CAT succesfully at the remote site only.

I have SDC, Omnirig and the IK0VVE or2or.exe software but I don't know haw/where to start.

I am a newcomer with Log4OM and it will be very hard for me, due to lack of time, to leave my MacLoggerDX software with over 85K QSO logged, but I will try!

I look forward for help from this community and wish all of you good DX and luck.

73 de Fabio, IT9GSF - One of the II9P/IG9A team.

[G4POP]

Best use Teamviewer or Anydesk to remotely control the software at the remote site

[it9gsf]

I have one monitor only at the remote site and three here at home. I need not a so easy solution. Regards, Fabio.

[it9gsf]

Also, please, consider I have a local station at my home and I would like to connect (cat) a second and third radio here.
CUL,
Fabio.

[G4POP]

So use one local screen for Anydesk to remote PC

And using your local install of Log4OM control the other two rigs via Omnirig locally on the other two screens

[it9gsf]

THANK YOU!