Re: Trying to get setup on V2
Posted: 26 Feb 2020, 17:29
Hi Rich,
first of all, i don´t use these function so my indoor wires don´t need a rotator, HI. By the way,
the function should be rotate your antenne if a callsign is entered to the Call field in main UI
and the data was coming up for antenna position. Another "by the way" is that the controller
of your rotator must be listen to the same IP and Port which is setted up in V2.
Please also do a fresh download of the manual (Guide) via the HELP button in V2. We´re on
an early release and some will be changed from version 2 version in the next release but
the guide (manual) is updated nearly each day at this time.
By the way, the PDF is full searcheable. If you use the search function you can enter the keyword
PSTrotator and start a search. Much easier then looking to the index and try to find out which
sides are relevant ...
Wish you luck with your setup and thank´s using V2 ...
first of all, i don´t use these function so my indoor wires don´t need a rotator, HI. By the way,
the function should be rotate your antenne if a callsign is entered to the Call field in main UI
and the data was coming up for antenna position. Another "by the way" is that the controller
of your rotator must be listen to the same IP and Port which is setted up in V2.
Please also do a fresh download of the manual (Guide) via the HELP button in V2. We´re on
an early release and some will be changed from version 2 version in the next release but
the guide (manual) is updated nearly each day at this time.
By the way, the PDF is full searcheable. If you use the search function you can enter the keyword
PSTrotator and start a search. Much easier then looking to the index and try to find out which
sides are relevant ...
Wish you luck with your setup and thank´s using V2 ...