VFO Issues

[VK4FSRD]

Good Day,

Sorry if this has already been asked, I am new to the Log4OM and just doing some testing, when I am working split freq and then I revert back to non-split the RX icon satys next to VFO b even though I am RXing and Txing on VFO A. Only way to resolve is to stop and start the program then all is good and it goes back to RX/TX on VFOA

I am using omnirig and a Yaesu FT-840.

Can anyone assist.

[G4POP]

Sounds like RF in the shack because it is working perfectly when tested here

[NN7D]

Also works fine on my installation using a IC-7600 and OmniRig.

Doug - W7DRM