Log4OM

Hi all! New LoTW TQSL 2.0 is available for download on the ARRL site. I downloaded it and installed and I can report that it is working just fine with Log4OM.

73

Be careful Aldo there are some issues with that which the LOTW user group are still working on, thats why I have not notified everyone.

G4POP wrote:Be careful Aldo there are some issues with that which the LOTW user group are still working on, tats why I have not notified everyone.

Thanks for the heads up Terry, It seems to be ok so far. this is RC7 and they also have a configuration update after you install.
I will report any problems as encountered.
Thanks again Terry.

73

VA3AG wrote:Hi all! New LoTW TQSL 2.0 is available for download on the ARRL site. I downloaded it and installed and I can report that it is working just fine with Log4OM.

73

Yep same here Aldo, no issues found at all and seems to be working (touching wood) quite effectively for me also

A new TQSL v2.0 out since yesterday. Can be downloaded at the LotW page. I´ve only downloaded but not tested yet.

Installed and tested. Don´t found any problems. Looks like working fine.

Working All OK here also.

Well, my installation did not go so smoothly. I downloaded ver. 2.0 with no problems, but when I attempted to upload QSOs to LOTW, after creating the ADI file, LogOM hung up. The updated TQSL program was in a different location from the previous version. I had to go into settings in Log4OM and change the address of my TQSL. A few minutes of panic when I realized the great software I was using had a glitch, and it was something I did. But everything is fine now.

Art K0AY

I think that is a bit strange for the path to Tsql to change unless you originally installed it somewhere other than the default Tsql install directory?

K0AY wrote:Well, my installation did not go so smoothly. I downloaded ver. 2.0 with no problems, but when I attempted to upload QSOs to LOTW, after creating the ADI file, LogOM hung up. The updated TQSL program was in a different location from the previous version. I had to go into settings in Log4OM and change the address of my TQSL. A few minutes of panic when I realized the great software I was using had a glitch, and it was something I did. But everything is fine now.

Art K0AY

I will check the procedure that runs TQSL to see if there are issues when software is not found where it's expected.
Thanks for reporting