Log4OM

Hello.
In the "COUNTRY" column, at times, the country is not displayed while the LOCATOR of my correspondent is well informed. Do you have an idea ?
73 to all.

Screenshoot here:
http://www.f1nqp.fr/Capture/Log4OM_problem.png

JTalert or wsjt did not pass the country to Log4om, ask them why

I do not use Jtalert but only JTDX. It's possible, I'll see on this side.
Thank you 73 G4POP

Check the JTDX log

Using WSJT-X and GridTracker. Same problem here since I started using Log4OM's communicator. In my opinion, country info is not part of the log entries forwarded to Log4OM. Rather I would expect Log4OM to populate the "country" field in the same way as when importing an ADIF file.

73, Markus HB9BRJ

Hello.

I just updated LOG4OM.
I checked the ADIF file of JTDX and it is OK.

If I import into LOG4OM the ADIF file from JTDX again, I risk duplicates?
Of 3540 entries, I have about 200 who do not have the country.

Thank you in advance for the answer and good day to all. 73

Why not use the QSO Manager to update the country names

I did not know there was a possibility by the manager. I try now. Thank you.

Am using always the latest Log4OM version also the latest JTDX and JTAlert. I have found only one
contact without a Country entry an that is D1WW which has no DXCC status .... On my side all is fine.

it's good it worked.
All the countries are now informed, and I had duplicates.
Thanks for the tip Terry.
73 and good traffic.

F1NQP Jean-Jacques