Page 1 of 1

"My refs." not available when "Edit QSO"

Posted: 27 Jun 2020, 21:08
by LB4MI
Hi,
(v2.7.0.0)

For some QSO's, it's not possible to add an award later on.

E.g. in the picture underneath, I want to add the SOTA reference to the filtered QSO's. As shown, the "My references" are empty, and I right-click and "Edit QSO", and open "My refs."

When I try to open the drop-down list of "Award", it's empty (as shown).

Any ideas? The QSO's are made with V1 of Log4OM, as they are from before V2. But I'm not sure if this is the reason... I don't see any logic pattern...
Merknad 2020-06-27 230040.jpg
Merknad 2020-06-27 230040.jpg (219.26 KiB) Viewed 2685 times

Re: "My refs." not available when "Edit QSO"

Posted: 27 Jun 2020, 22:08
by G4POP
Fixed in next release

Re: "My refs." not available when "Edit QSO"

Posted: 03 Jul 2020, 12:58
by LB4MI
Hi, no change in 2.8.0.0, still not possible to add award. The "Award" is blank when I open it.

11111111.jpg
11111111.jpg (85.46 KiB) Viewed 2655 times

Re: "My refs." not available when "Edit QSO"

Posted: 03 Jul 2020, 13:01
by G4POP
EMAIL me a support request please

Re: "My refs." not available when "Edit QSO"

Posted: 06 Jul 2020, 19:55
by LB4MI
Hi any future reader,

the cause of the above issue was that the "My QTH" did not have Country and GridSquare filled in.
Once this data was entered, I could add "My Refs." with no problem.
123123123213123123.jpg
123123123213123123.jpg (79.55 KiB) Viewed 2623 times