Page 1 of 1
Reading Freq and band using other sw.
Posted: 13 Aug 2020, 17:53
by iz6gvc
Hi,
I play Log4om, wsjt-x and jtalert, all the sw works fine.
Now I would that log4om reads band and frequency from the radio, but the cat is already used from wsjt-x.
How can I run all the sw by the CAT without any conflict?
Tnx and 73s
Inviato dal mio POCO F1 utilizzando Tapatalk
Re: Reading Freq and band using other sw.
Posted: 13 Aug 2020, 18:14
by G4POP
Camollio,
Please check latest user manual.....?
You must use Omnirig
You must 'Run ALL programs as an administrator'
You must select OMNIRIG in WSJT NOT YOUR RADIO
It's all in the user guide, but I have to constantly repeat this because no one reads it!
Re: Reading Freq and band using other sw.
Posted: 13 Aug 2020, 20:10
by iz6gvc
G4POP wrote:Camollio,
Please check latest user manual.....?
You must use Omnirig
You must 'Run ALL programs as an administrator'
You must select OMNIRIG in WSJT NOT YOUR RADIO
It's all in the user guide, but I have to constantly repeat this because no one reads it!
Hi Terry,
thanks for your reply, I will read with very accuracy the manual for the settings.
I hope you can play your holidays soon as possible.
73s Camillo
Inviato dal mio POCO F1 utilizzando Tapatalk
Re: Reading Freq and band using other sw.
Posted: 13 Aug 2020, 20:52
by G4POP
Be sure to download the latest user guide