Log4OM

I programmed 2 receivers in Omnirig
When i active the CAT of the first receiver in log4om, all is ok
But impossible to active the CAT of the second receiver in log4om

Is it normal?

No, i have 2 transceivers running and all is fine. Did you run Log4OM and Omnirig and/or other
related softwares as administrator as described in the user manual ? Have you different COM
ports for those 2 receivers ? If a COM is used by Omnirig1 it can´t be used for Omnirig2.

ON4OM wrote: 09 Oct 2020, 07:46 I programmed 2 receivers in Omnirig
When i active the CAT of the first receiver in log4om, all is ok
But impossible to active the CAT of the second receiver in log4om

Is it normal?

I also have 2 rigs connected to omnirig and I am using log4omv2. I can switch between rigs using Log4om. Make sure you are using 2 different com ports. I recently just upgraded to omnirig 1.19. User guide here is very helpful.

Hi,

I work with Omni Rig with out problem. It works fie with JTDX and both Softwares have CAT

I had version 1.19 and I move back to 1.18 with better performance... With 1.19 I had some small cuts.

73 de Jose EC6DX

EC6DX wrote: 12 Oct 2020, 15:47 Hi,

I work with Omni Rig with out problem. It works fie with JTDX and both Softwares have CAT

I had version 1.19 and I move back to 1.18 with better performance... With 1.19 I had some small cuts.

73 de Jose EC6DX

Hello
What is better about 1.18? What do you mean by cuts? I am using 1.19 and I dont see any issues

Hi...

I was using 1.19 and I changed to 1.18 because I loose conection sometimes... With V 1.18 all is better between JTDX and Log4OM

I can not explain why because I am a very poor technician... hihihi... It is my experience...

Log4OM works perfectly using Omni Rig with JTDX !!!

Jose