Page 1 of 1
Entry field wipe
Posted: 05 Jan 2021, 11:49
by m0eas
Is there any feature / parameter which activates clearing/ wiping the callsign entry field if the frequency is changed?
I am aware pressing ESC works but not always if I happen to have clicked into a different application such as HDSDR.
N1MM has this. Very useful as often I just enter a callsign in the box to view information whilst scanning through the band.
Re: Entry field wipe
Posted: 05 Jan 2021, 11:58
by KI5IO
m0eas wrote: 05 Jan 2021, 11:49
Is there any feature / parameter which activates clearing/ wiping the callsign entry field if the frequency is changed?
I am aware pressing ESC works but not always if I happen to have clicked into a different application such as HDSDR.
N1MM has this. Very useful as often I just enter a callsign in the box to view information whilst scanning through the band.
OM,
Tapping the red X at upper right corner of Main UI will wipe all information present for that entered callsign.
That is how I check stations while scanning bands.
Re: Entry field wipe
Posted: 05 Jan 2021, 16:31
by m0eas
Is it possible to request this as a new feature?
Re: Entry field wipe
Posted: 05 Jan 2021, 23:44
by G4POP
Moved thread to Feature suggestions
Not a thing I would want personally, sounds like a PITA unless it could be disabled! especially as there are other safer ways to clear the field like esc, backspace or the cancel X
Re: Entry field wipe
Posted: 10 Jan 2021, 11:49
by m0eas
Thanks, yes certainly would need to be a parameterised feature and maybe operate when frequency changed by a reasonable margin.