Page 1 of 1
Wrong frequency when double click in cluster
Posted: 26 May 2022, 15:45
by pa5mr
I Have a weird problem. If I double click on a station in the cluster view the set automatically goes to the frequency of that station. This works well but lately i have noticed that the frequency is off. EG the cluster frequency is 7112 ant the set goes to 7113.30. If i double click again it goes to 7112.
Log4om 2.22
Ominirig
FT991A
Anyone else experience this behavior? Any solutions?
73 PA5MR
Re: Wrong frequency when double click in cluster
Posted: 26 May 2022, 17:38
by KI5IO
pa5mr wrote: 26 May 2022, 15:45
I Have a weird problem. If I double click on a station in the cluster view the set automatically goes to the frequency of that station. This works well but lately i have noticed that the frequency is off. EG the cluster frequency is 7112 ant the set goes to 7113.30. If i double click again it goes to 7112.
Log4om 2.22
Ominirig
FT991A
Anyone else experience this behavior? Any solutions?
73 PA5MR
Mario,
Check your Configuration / CAT setup. It is possible that you have turned on the offset.
Re: Wrong frequency when double click in cluster
Posted: 01 Jun 2022, 10:29
by OM6AI
I have the same issue on the latest stable version Log4OM with FT-991A. Sometimes is frequency shifted on TRX after double-click in cluster. Offset in CAT configuration is turned off.
Re: Wrong frequency when double click in cluster
Posted: 01 Jun 2022, 11:43
by G4POP
OM6AI wrote: 01 Jun 2022, 10:29
I have the same issue on the latest stable version Log4OM with FT-991A. Sometimes is frequency shifted on TRX after double-click in cluster. Offset in CAT configuration is turned off.
Try selecting 'Send mode before frequency to radio' in settings/program config/CAT Interface menu
Re: Wrong frequency when double click in cluster
Posted: 02 Jun 2022, 08:30
by OM6AI
G4POP wrote: 01 Jun 2022, 11:43
OM6AI wrote: 01 Jun 2022, 10:29
I have the same issue on the latest stable version Log4OM with FT-991A. Sometimes is frequency shifted on TRX after double-click in cluster. Offset in CAT configuration is turned off.
Try selecting 'Send mode before frequency to radio' in settings/program config/CAT Interface menu
Thank you, everything is working properly for now.