Log4OM

My Yaesu FT-DX10 is connected via CAT. Tuning the radio changes the frequency/band in Log4OM. However, when using the cluster, if I click on a spot, it loads the call sign information but does not change to that frequency.

Is it supposed to change the frequency? If yes, is there a setting to enable/disable it?

Double click is the same as single click - it populates the call sign information but no change in frequency.

The frequency does change when using the band map tool.

The radio is connected via Omni-Rig and running portable Version 2.26.0.3 BETA

First your welcome. Out of date please install latest Beta release

Change omnirig polling rate to 100

Single click = lookup

Double click = lookup and QSY

Terry,

Are these settings in OmniRig?

• Single click = lookup
  Double click = lookup and QSY

I do not see settings like this.

The polling rate is set to 100ms.

W4RXK wrote: 07 Apr 2023, 14:50 Terry,

Are these settings in OmniRig?

• Single click = lookup
  Double click = lookup and QSY

I do not see settings like this.

The polling rate is set to 100ms.

No I was just describing how Log4OM cluster works as detailed in the user guide