CW mode always set to CWL after clicking a cluster station
Posted: 17 Mar 2025, 06:49
Hi everyone,
I have an issue with properly setting the CW sideband when clicking on a CW station in the LOG4OM cluster. Thetis always sets CWL, never CWU as it should.
My setup:
Thetis 2.10.3.8
LOG4OM: 2.35.1.0
Connection via TCI server to Log4OM
The option "CWL/CWU becomes CW (out)" is checked in Thetis
Settings/Program config/CAT interface/Check box 'Invert SSB side (CW) is checked in Log4Om
Sometimes, after resetting the TCI server in Thetis a few times, it works correctly—but upon restarting the software, the issue comes back.
It switches to USB modulation correctly. The problem occurs only in CW spots.
Has anyone found a fix for this problem?
I have an issue with properly setting the CW sideband when clicking on a CW station in the LOG4OM cluster. Thetis always sets CWL, never CWU as it should.
My setup:
Thetis 2.10.3.8
LOG4OM: 2.35.1.0
Connection via TCI server to Log4OM
The option "CWL/CWU becomes CW (out)" is checked in Thetis
Settings/Program config/CAT interface/Check box 'Invert SSB side (CW) is checked in Log4Om
Sometimes, after resetting the TCI server in Thetis a few times, it works correctly—but upon restarting the software, the issue comes back.
It switches to USB modulation correctly. The problem occurs only in CW spots.
Has anyone found a fix for this problem?