always no tx fldigi & log4om

[HB9VQQ]

Bonsoir Eric,

that's the Magic built in Log4OM

Unbenannt.JPG (54.82 KiB) Viewed 6421 times

Unbenannt1.JPG (52.7 KiB) Viewed 6421 times

73
Roland

[F1SMV]

gm Terry
ah may be where ? because morning i check again setup in log4om and i cant see anywhere xml rpc ..only in flidigi i can see

fldigixml.PNG (10.42 KiB) Viewed 6408 times

73 Eric

[F1SMV]

Roland
i check , its ok i have same that you..in TCP-IP sessions

73 Eric

[G4POP]

gm Terry
ah may be where ? because morning i check again setup in log4om and i cant see anywhere xml rpc ..only in flidigi i can see
fldigixml.PNG

73 Eric

Not sure what version of FLdigi your using but it should be 4.1.08 or later and you need the I/O config tab not rig control

[IK0TIX]

sorry if I insist, but I think that Eric's problem continues to be the com port is not split.
N8VBvcom does not do this but only virtual com.
The original problem was no TX

[F1SMV]

Bonjour Terry

i use fldigi 4.1.09.12 version ...

Mark
do you think i must back on vspe ? ..but i try without more success..

this morning i test in same cfg my "old version" of log4om (version 1), work ! tx is ok

for your info i put my setup , i see tcp port arent the same does i must change in misc\tcpip sessions ?

Capturefldigiold.PNG (91.86 KiB) Viewed 6370 times

73 Eric

[IK0TIX]

Indeed Eric.
I don't remember if in V1 I used the com splitter port.
Certainly V2 does not command TX via TCP / IP, or at least it does not work for me.
This is why I insist on splitting the com port.

@ Terry: Can Log4OM V2 send the rig in TX via TCP/IP?
Thanks

[G4POP]

Indeed Eric.
I don't remember if in V1 I used the com splitter port.
Certainly V2 does not command TX via TCP / IP, or at least it does not work for me.
This is why I insist on splitting the com port.

@ Terry: Can Log4OM V2 send the rig in TX via TCP/IP?
Thanks

No and neither did V1, PTT is triggered within FLDigi

[SQ5TDZ]

GM
in earlier versions of fldigi the connection of log40m v1 with fldigi worked without a problem, now these versions of fldigi do not want to work even with other software, as separate software works without a problem. this is my observation
Regards

[s51cn]

HI Eric
FLdigi 4.1.09 has new look of Configuration window and look on picture where you find TCP-ip session.
It is working for me.
73 Bojan S51CN