Connecting LOG4OM to FLEX 6300

[AH6TX]

I have your program working on my TS-480HX just fine. I just purchased and installed a flex6300. The procedure to work with CAT systems for the FLEX is to first install SmartSDR CAT. In doing so the program identified the following:
to connect to com port 4. My next step was to load OmniRig and make the COM PORT 4 into RIG2. The only problem is you don't have a selection for the FLEX 6300. I spoke with Flex and they suggested either TS-2000 or PowerSDR, which is there old software. In either case I could not get it to work.

Please advise what I need to do to connect your software to my FLEX.

Thanks

Howard Krawitz
AH6TX
[email protected]
661-821-0923

[ik2egl]

ciao Howard ,

I did a check and based on the information provided all seems to be fine.

I have only 2 questions:

1) why do you use RIG2 instead of RIG1 ?

2) do you have other vitual port emulator working in the same time with smartcat ? (you can also check in system resource if there are other com port available not defined by the smartcat ).

try also to create a new "dedicated" port in smartcat (com5) and try to use COM5 instead of com4

keep us informed !

[AH6TX]

Not sure how you would create a new port. I used rig2 until I am sure I am going to keep the 6300.
I don't have anything else running. Smartsdr cat say to use port 4.
Which interface should i use TS-2000 or what?

Your help is appreciated.
Thanks

Howard
AH6TX

[ik2egl]

the ts2000 is the right one.
check also the manual of log4om where you can find
a specific paraghaph I wrote on flex signature integration
let me know

[AH6TX]

Thanks for your info. I found the info in the manual, however the SMART CAT indicates to go to COM4. How can I change that for 5 as it indicates in the manual? Smart Cat has some options but I don't know how to use them. Please advise.

Thanks

Howard
AH6TX

[ik2egl]

enter in the smartcat menu and create a new port as dedicated (not shared, not ptt).
have a look at smartcat manual as it is fully explained

[AH6TX]

have looked for the manual and can't find it. I have smartsdr cat ver 1.2.8.0. If you have a copy can you send it to me. [email protected]

Thanks

Howard

[ik2egl]

manual sent !

[G4POP]

have looked for the manual and can't find it. I have smartsdr cat ver 1.2.8.0. If you have a copy can you send it to me. [email protected]

Thanks

Howard

In Log4om go to help/help/English - Force update then view the downloaded help file

Alternatively the manual download link is just below the link you used to download the program

Page 201 refers

[ik2egl]

hi Howard
was you able to do make 6300 integrating with log4om ?

if you need support I am available in the weekend also on skype

let me know