LOTW error when Log4OM is set to Admin Priviledge

[k4em]

I setup Log4OMv2, Omnirig, WSJT, JTAlert (all the latest versions) to all have Admin Privilege's. I have it configured and working with my Anan 7000DLE MK II SDR radio. So after a few days of learning Log4OM I uploaded my QSO's to LOTW, I received a TQSL error stating I couldn't run it with Admin Privilege's. I removed the Admin Privilege's from Log4OM and it Uploaded fine with no issues, next morning I completed the LOTW Download with no issues. TQSL is NOT set with Admin Privilege's as stated on the LOTW site.

Is there something I over looked? I reviewed the Forum and found no info on this problem I also reviewed the 8/2/2020 manual.
Thanks,
Dave
k4em

[G4POP]

No only programs sharing Omnirig for CAT control need to be run as an administrator to permit multithreading of the data for the com port

[k4em]

Here is the error I receive when I upload my logs to LOTW. Turning off Administrator Privilege's I do not get this error.
It is asking to choose one. My question, is it OK to chose the last selection 'Always allow running as Administrator'?

Dave
k4em

[G4POP]

Here is the error I receive when I upload my logs to LOTW. Turning off Administrator Privilege's I do not get this error.
It is asking to choose one. My question, is it OK to chose the last selection 'Always allow running as Administrator'?

Dave
k4em

Personally I would exit and reset the run as administrator settings in Properties but its your choice