Version 2.10.0.0 - Double click on Bandmap not working - SOLVED

[F4HGU]

Salut Pat

what worries me in your omnirig settings :

For me DTR and RTS have to set "Low" not "High"
AND
You have the same value for the Polling interval and the Timeout Interval
For me the Timeout MUST be higher than the Polling ...
73

I try, thanks Daniel !

[F4HGU]

Daniel, you are the Boss !! Thank you, it works !!

Terry, thank you very much for your support. I love this software !

The issue is fixed with the following parameters. If that could help somebody else.

omnirig_FT1000MP.PNG (6.62 KiB) Viewed 3767 times

[F6FLU]

Thanks

[ON7WF]

Hello Dan,
I also had a very slow working log4om V2 and version 2.10 was a real catastrophy! So I started digging around and came across your topic. I did a clean install of log4om V2 and omni-rig and I applied your last posted omni-rig settings and what a revelation, log4om V2 is finally working at an acceptable speed.
Thanks a lot.
ON7WF - Wil

[F6FLU]

Hi
very happy to have been helpful
For some explanations :
DTR means Data Terminal Ready (use for CW)
and
RTS means Request To Send (use for PTT)

Soon all this help and detailed explanations in French on my site ....Wait & See

73

[ON7KZ]

Same issue here on my ftdx101 it happens always during the time from data lookup, so have put back 2.9 version
73 Luc, ON7KZ

[G4POP]

Same issue here on my ftdx101, so have put back 2.9 version
73 Luc, ON7KZ

Did you try the fix above?

[ON7KZ]

Yes,
I have trying it all, its happens during time "data lookup"
73 Luc